Elara is a two way floorstanding speaker.
Elara is a bass-reflex cabinet loudspeaker with drivers of Mundorf and Visaton.
The kit is delivered with the following drivers:
- a Mundorf ProAMT 88PP27R-8-462-H air motion transformer (ribbon-tweeter)
- a Visaton W 250 S, 4 Ohm woofer
The loudspeaker has been developed by Thomas Schmidt and Holger Barske.
The crossover consists of:
- a 2nd order high-pass filter (12 dB per octave slope) for the tweeter.
- a 2nd order low-pass filter (12 dB per octave slope) for the woofer.
The frequency response of this speaker is nearly linear.
The decay spectrum is nearly perfect.
At low volume, i.e. 85 dB at 1 m, the nonlinear distortions are below 0,9% above 200 Hz and doesn't exceed 1,2% at 95 dB at 1 m between 300 and 15000 Hz.
the crossover components (right),
to be mounted on a small wooden board.
Kit without cabinet, price per speaker EUR 574,15 excl. VAT: € 494.96 / $ 579.10
The high-end kit is delivered with baked varnish air core coils on important parts of the crossover for minimizing microphonic effects. - The current flow through the coil creates a magnetic field which sets the reel of wire in motion. This motion induces a voltage in the coil which adds itself to the signal. The stiffer the reel of wire is, the less the signal will be altered. The capacitors for the Mundorf ProAMT 88PP27R-8-462-H are of type polypropylen (MKP) Clarity-Cap CSA.
Kit with high-end-crossover without cabinet, price per speaker EUR 617,04 excl. VAT: € 531.93 / $ 622.36
If you want to use a valve amplifier with this speaker an impedance correction should be employed. In this case the component quality is less important; therefore, we offer only one kit (upon request higher quality components are available).
Price per impedance correction for one speaker, to be mounted on a small wooden board. EUR 13,94 excl. VAT: € 12.02 / $ 14.06
If you prefer to mount the crossover components on a universal PCB instead on wood
PCB 150x115 mm, tin plated, price per unit: EUR 4,58 excl. VAT: € 3.95 / $ 4.62
We recommend one board per kit (2 boards per speaker pair)