Elysion is a two way floorstanding speaker.
Elysion is a dipole loudspeaker with drivers of Mundorf and ScanSpeak.
The kit is delivered with the following drivers:
- a Mundorf AMT25D6.1-R air motion transformer (ribbon-tweeter)
- a ScanSpeak 21WE/4542T00 midrange / bass driver
The loudspeaker has been developed by Bernd Timmermanns.
The crossover consists of:
- a 2nd order high-pass filter (12 dB per octave slope) for the tweeter.
- a 2nd order low-pass filter (12 dB per octave slope) for the mids-woofer.
The frequency response of this speaker is perfectly linear.
The decay spectrum is perfect.
At 90 dB and 1 m, nonlinear distortions are below 1 % almost everywhere above 50 Hz.
the crossover components (right),
to be mounted on a small wooden board.
Kit without cabinet, price per speaker EUR 1507,00 excl. VAT: € 1266.39 / $ 1380.36
The high-end kit is delivered with copper foil coils for minimizing microphonic effects. - The current flow through the coil creates a magnetic field which sets the reel of wire in motion. This motion induces a voltage in the coil which adds itself to the signal. The stiffer the reel of wire is, the less the signal will be altered. The capacitors for the Mundorf AMT25D6.1-R are of type Mundorf MCap Supreme Evo Oil.
Kit with high-end-crossover without cabinet, price per speaker EUR 1675,00 excl. VAT: € 1407.56 / $ 1534.24
If you want to use a valve amplifier with this speaker an impedance correction should be employed. In this case the component quality is less important; therefore, we offer only one kit (upon request higher quality components are available).
If you prefer to mount the crossover components on a 240 x 165 mm universal PCB instead on wood:
Universal PCB RA240, order no.. I-2767, price per unit: EUR 7,60 excl. VAT: € 6.39 / $ 6.96
We recommend one board per kit (two boards for a speaker pair)
Hobby HiFi Overview