Copernicus Top aktiv   Altavoz de pared por K+T 2/2022

Datos técnicos
  • Impedancia: 6 Ohm
  • Nivel de presión sonora (2,83V/1m): aktiv dB
  • Dimensiones (ancho x alto x profundidad): 600 x 600 x 300 mm
  • Rango de frecuencia (-8dB): 48 a 29000 Hz
  • Frecuencia (s) Crossover: 300, 2150 Hz
  • Principio: Carcasa cerrada

La Copernicus Top aktiv es una caja acústica compacta de tres vías

El Copernicus existe en cinco versiones:

Copernicus Top aktiv es un altavoz cerrado con chasis fabricado por la empresa Mundorf y la empresa Wavecor.

El kit incluye los siguientes altavoces:
- un transformador air motion (altavoz de agudos de cinta) Mundorf AMTU160W1.1-R
- dos altavoces de medios Wavecor WF182CU13
- un altavoz de graves Wavecor WF259PA01

La columna de altavoz Kura ha sido desarrollada por Dennis Frank y Daniel Gattig.

La respuesta de frecuencia del altavoz es perfectamente lineal.

El diagrama de cascada es modélico, exento de cualquier tipo de resonancia molesta.

Las distorsiones no lineales a volumen bajo (85 dB, 1m) se sitúan por sobre los 500 Hz y bajo 0,5%, manteniéndose incluso a 95 dB, 1m, en el rango audible, bajo 0,6% .

Extracto del test de audición de la revista Klang+Ton (Traducción del autor al inglés)

"The Copernicus´ performance with the free-field setting directly in front of the wall is impressing, but in the long run it is clearly too powerful. So I first turned the bass department down by about 6 decibels - that´s better. The impression of infinitely deep and dynamic bass is retained, but it doesn't immediately jump in the listener's face (or stomach). This impression extends over the entire audible frequency range: you can clearly hear that there is significantly more membrane area in every position than with your standard loudspeakers. And because the whole thing is so beautifully linear and without any distortion, you can always get really loud without stressing your ears - very good! When it comes to home cinema, things are going just as well... I caught myself stepping on the gas on the subs for the correct doomsday soundtrack à la "Independance Day" or "2012" - but then that's not entirely possible without worrying about the building´s structural integrity…. "

Conclusiones de la revista Klang+Ton:

" Perfectly tuned wall box with an integrated subwoofer solution that leaves no desires whatsoever. "

"High-end tip"

Nuestro kit de montaje se compone de

  • 2x WF182CU13, Wavecor Mid/Woofer, 8 Ohm, paper cone, BD, phase plug
  • Mundorf AMTU160W1.1-R
  • Wavecor WF259PA01, 8 Ohm, professional woofer
  • Hypex FusionAmp FA253
  • Damping fleece MT Bondum 800 (30 x 50 x 2 cm)
  • 3x Damping Sonofil 100 x 35 cm for 20 litres
  • 2,5x Pan screws 3.5x17 black, torx, 8 pieces
  • 1,5x Pan screws 4x20 black, torx, 8 pieces
  • Allen wood screws, black, 5x30 mm, 8 pieces
  • Plan for DIY kit

Kit sin la caja, precio por altavoz   EUR 2100,00 sin IVA: € 1764.71 / $ 1905.88

El precio de un par de altavoces personalizados con el color deseado.  EUR 6648,00 sin IVA: € 5586.55 / $ 6033.48

Medidas en este altavoz

measurmentsMedidas en este altavoz

Atrás   Vista general de las recomendaciones para construcción de la Revista Klang und Ton